Engine Performance. Test 8
Engine Performance. Test 8
If the pressures in the MV and the SV bellows are equal, what will be the output pressure Pu of this pneumatic P-controller ?
If the length of 'a' is equal to the length of 'b' what will be the proportional band 'PB' of this pneumatic controller ?
Suppose the Proportional Band of this pneumatic controller is increased to 500 % and the input variation remains the same. What would be the output variation ?
What measure of power developed inside a cylinder is obtained by using the formula PMI x cylinder section surface (cm2) x stroke (metre) : 75 ?
For which type of controller are these the input (left) and the response (right) characteristics ?
An engine develops 2500 IHP and the BHP is 2000. What is the mechanical efficiency?
What is the amplification factor (K) of a pneumatic amplifier ?
In this electrical amplifier drawing, what takes the place of the flapper/nozzle unit used by the pneumatic control unit with amplifier ?
Thermal efficiency refers to heat engines and is the ratio of _____
This characteristic shows output pressure of a pneumatic controller controlling water level. The level is fluctuating. What is wrong with the setting of the controller.?
Review Answers
