Maintenance, Repair. Test 12
Maintenance, Repair. Test 12
What is the purpose of the calliper shown in the bottom left corner ?
During a plasma cutting process the workpiece was not totally penetrated. What would be the most likely problem?
Which type of examination reveals pin holes, slag inclusion and lack of fusion?
After sharpening a twist drill, which points are the most important to check?
What kind of tool is shown right bottom and into what does it fit ?
What feature of a good weld is indicated by No.4 ?
What tool is shown bottom left and for what is it used ?
When using third angle projection, viewing the component from x, which drawing will be above the front elevation?
What is shown in No. 1 ?
What is the measuring device shown in the top and what is it used for ?
Review Answers
