Engineering, Control Systems. Test 52
Engineering, Control Systems. Test 52
What does the symbol drawn on the fourth line form the top (a blank circle) indicate in an automation schematic diagram ?
What does a non-articulated full line indicate in an automation schematic drawing ? (the third line from top shown here)
When making heavy cuts on a milling machine how is the work piece secured?
What effect has setting the tool too low on a centre lathe?
What would be a suitable feed speed when rough turning alloy steel in a centre lathe?
What tool fitting method is normally found in the tailstock of a centre lathe?
Which is the correct method for removing intact engineers studs?
When using a centtre lathe, what would be used for turning short tapers as in chamfers?
What does the symbol shown on the fifth line from the top (a circle with a horizontal line through it) of the drawing indicated an automation schematic diagram ?
On a centre lathe what advantage is there in using a mandrel on a bored work piece?
Review Answers