Engineering, Control Systems. Test 47
Engineering, Control Systems. Test 47
When turning a long work piece in the centre lathe what is the most frequent problem?
When using a centre lathe, when would a driver be used?
When using a milling machine to reduce the thickness of a parallel key how is the material marked?
When using a milling machine to reduce the thickness of a parallel key how is the work piece set up once the material has been marked?
When used in instrumentation what does a potentiometer record?
When cutting a steep helix in the centre lathe, as in multi start threads, what tool angle must be altered?
What cross section is the front saddleway on a centre lathe?
Which of these requires the lowest cutting speed?
What does the indexing dial indicate on a centre lathe?
If a leak is suspected in a tube heat exchanger what should be checked first?
Review Answers