Maintenance, Repair. Test 12
Maintenance, Repair. Test 12
After sharpening a twist drill, which points are the most important to check?
What is the measuring device shown in the top and what is it used for ?
What tool is shown bottom left and for what is it used ?
What is the purpose of the calliper shown in the bottom left corner ?
What is shown in No. 1 ?
What kind of tool is shown right bottom and into what does it fit ?
When using third angle projection, viewing the component from x, which drawing will be above the front elevation?
What feature of a good weld is indicated by No.4 ?
Which type of examination reveals pin holes, slag inclusion and lack of fusion?
During a plasma cutting process the workpiece was not totally penetrated. What would be the most likely problem?
Review Answers
