Engineering, Control Systems. Test 58
Engineering, Control Systems. Test 58
When using a drill in a centre lathe, how is this fixed to the tailstock?
At what temperatures would a pyrometer be used?
What instrument uses a Venturi?
How is the cutting tool ground when thread cutting on the centre lathe?
Why is one tube end a packed gland in tube coolers?
How would a large flat area be cut on a vertical milling machine?
What top rake angle would be used for turning Aluminium in the centre lathe?
When could a magnetic chuck be used on a centre lathe?
If the valve wheel (5) is moving very freely, but you suspect that the valve is neither opening nor closing, what are you going to check first ?
What item must be regularly inspected in SW heat exchangers?
Review Answers
