Engineering, Control Systems. Test 45
Engineering, Control Systems. Test 45
On a centre lathe how is the work piece secured to the faceplate?
How could drilling and tapping be carried on the centre lathe with an irregular work piece?
What top rake angle would be used for turning cast iron?
On a centre lathe, when turning without a centre, how much of the work piece may extend beyond the chuck?
How is the surface gauge secured to the bed of a centre lathe?
What change is made for finish turning in a centre lathe?
What are lathe beds manufactured from?
What would be measured with a tachometer?
What should be adjusted if a taper is to be machined on a centre lathe?
On a centre lathe what is a 'live centre'?
Review Answers