Engineering, Control Systems. Test 40
Engineering, Control Systems. Test 40
Which of these locking devices can be used more than once?
On a centre lathe with a lead screw pitch of 5mm it is required to cut a thread of pitch 2mm, what is the required drive/driven gear ratio?
When would a three-jaw chuck not be used on a centre lathe?
In bolt sizes what does AF refer to?
Which component of a general service air compressor requires most maintenance?
In which machinery can you not add oil when running?
What is the name for a milling machine capable of both vertical and horizontal milling?
On which machine tool does the work piece not move?
What part of a pneumatic control system is this ?
What is the principle advantage of the three-jaw chuck on a centre lathe?
Review Answers