Engineering, Control Systems. Test 11

If the cooling water temperature goes below it's recommended value, what can happen ?

What is the purpose of part number 6 ?

You have installed a new bearing in the main engine. What is the necessary action to take during the running in period ?

No action is required to be taken.
Stop after 30 minutes running and hand feel the bearing.
Allowance must be made for a running in period with reduced speed and careful temperature monitoring.
Allow for one hour running with appropriate temperature monitoring of the bearing.

During manoeuvring with the main engine, what is the arrangement for starting air supply by the main air compressors ?

What liquid is used to clean the turbo charger of a large low speed main engine? (high speed air side, half speed gas side)

The turbocharger (constant pressure) is making 'whoofing' noises. What might be the cause ?

After fitting a new cylinder liner to a 2 -stroke engine which of the following steps should be taken?

Over which components does the Blending Unit Controller act in order to blend fuel of the required viscosity?

Review Answers